gas lenes - frist welds not so good

[dgarnier]

ok I see 1300 is not ruuning out...down to 1100 now...bumping the flow up tp 15cph did the trick on aluminum so far, and getting nice beads

[Timberwolf]

Your regulator should be seeing about 45 psi when it's flowing. SO use the tank until it's all the way gone. No sense in wasting some of that gas before ya gotta

[dgarnier]

ok will do - and here I was ready to take it back at 1000psi

[Ray]

ok will do - and here I was ready to take it back at 1000psi

Yea, it's still allmost half full.
It's like the tank in my truck, the second half seems to go faster than the first half.

[Timberwolf]

Just weld away till it's empty. How big of tank is it?

[dgarnier]

330cf - been running the 250 quite a bit since I got it

[dgarnier]

Well I didnt want to get stuck over the weekend with no gas, I took it down to a little under 100psi and took it in for an exchange. The refill was 4$ less this time, glad I got the 330 rather then a smaller tank