Well I got the new machine this afternoon and got everything fired up and working. I messed around on some 1/4" stuff and I must say I am impressed. It seems to cut as good if not a little better than the old Cutmaster did. The only issue I had after unpacking and inspecting was the little water trap that comes with it leaks at the inlet side around the threads no matter what you do. I tried pipe dope and thread tape and nothing will make it quit. I assume its cracked? I will try to locate a comparable replacement I guess. I am glad I got the A81 torch. Its more like what I am used to using.

I love the machine so far. I hope it lasts as long as I need it to. Quality of the machine and customer service are top notch. Mark was great to talk to and deal with. Thanks Everlast.