7 pin connector

[everlastsupport]

It is just the 7 pun connector, you will have to wire it. The switch is pin 1 and 2, just wire your new torch switch there.

[Timberwolf]

Mike I think it's two seperate questions. Is the torch switch that you sell the same one that is included when you order the 20 series torch? and if so, does it already have this 7 pin connector or does that have to be ordered seperate? I'd like to know the same things since I'll hopefully be ordering a 20 series torch here in the next few days

[everlastsupport]

Our WP20 comes with the switch in the torch and the 7 pin DIN on it. It is a complete torch for our units. Sorry, I did not understand the switch question when the topic was 7 pin connector. Do not buy the connector if you are buying the torch from us, it has one on it.

[Rugar]

I had one of your WP20 torchs and returned it. I know that it comes with the torch switch installed.
You also sell a switch seperate on your site. Im wanting to know if the switch you sell is the same one thats on your WP20? And does the switch that you sell come wired up with the 7 pin connector already installed?

[everlastsupport]

I had one of your WP20 torchs and returned it. I know that it comes with the torch switch installed.
You also sell a switch seperate on your site. Im wanting to know if the switch you sell is the same one thats on your WP20? And does the switch that you sell come wired up with the 7 pin connector already installed?

Still not sure I follow. Maybe Mark or Ray can help out.

I doubt the switch is the one from the WP20, but I could be wrong. The connectors would come with no wires as would the switches. The wires would be in the sheath and need to be connected at each end.

Can you send me a link to the part in question? I'll take a look.

[ogorir]

wouldn't you need to add a separate cable for the torch switch? all the tig cables I've ever seen just have a power conductor, and water lines if it's water cooled.

I think rugar is wondering
a) if the additional wire required to use the torch switch comes with the switch
b) if the switch does come with a wire, does it come with a 7-pin plug on the other end
c) if the switch that is pre-installed on the everlast WP-20 torch is the same switch you can buy separately

it sounds like a) and b) and c) are all a no, so to do what I think rugar wants (put an everlast switch on another torch to connect to an everlast machine) he'll need to buy a 2-conductor wire to zip tie to his torch lead. shurtape cloth tape under a lead jacket would probably work too with less chance of damaging the torch lead.

[Rugar]

Still not sure I follow. Maybe Mark or Ray can help out.

I doubt the switch is the one from the WP20, but I could be wrong. The connectors would come with no wires as would the switches. The wires would be in the sheath and need to be connected at each end.

Can you send me a link to the part in question? I'll take a look.

Half way down the page.
http://www.everlastgenerators.com/Ti...ucts.php?id=95