Search:

There were several torches that fit that unit. Having some idea of what torch was on it will dictate which torch you need.

Down. But you need 18" from all surfaces minimum during operation.

Likely bad outlet.

You can call tech support at 877 755 9353 ext 207 and they can help you.

9 to 10 is typical.

They break from over tightening. Very rare problem unless you put excessive force on it. Are you holding one side when you tighten the other as well? (using 2 wrenches)

Tec.mo and Innotec are cousin companies, actually related by blood, both of Italian ownership. One operates in China, the other operates in Italy (Tec.mo). They use a compatible design with each...

Call tech support at ext 207

Use the switch on the rear of the machine.

No it is not.

We have 3 different levels of 300A TIGs. We have the 315LX, 325EXT and Typhoon 330. Check them all out before you decide. They are all built well, and equally reliable. Just need to decide how...

Different models have it. Some do, some don't.

The Duramax torch will void the warranty.

Are you doing this for CNC? Or hand cutting?

Point gap should be .035" Make sure torch is in Negative. Replace work clamp cable as well. Preflow will delay your arc start. Keep that in mind. Make sure you aren't too close to your welder and...

Look in your manual for the consumable sizes. If it is shutting off, you are going too slow and loosing your arc or you have your air pressure wrong.

Make sure you have it set to auto restart.

Let us know if you need any help.

Here in the USA, we have a different opinion. We have found varying tolerances and design being sold. We do not advise any other than genuine tecmo and innotec replacement parts. Do not pay...

The weld was bad. He used an aluminum oxide padded palm sander to remove.....aluminum oxide.

Unfortunately it is full of errors and innaccurate statements. One of the plain that made me "palm face" was the use of cheap aluminum oxide sanding discs to remove aluminum oxide off of aluminum....

Ral 6018 is the old color.

No matches so far. But it is Pantone 355c if I recall correctly.

Welcome to our forum.

This was the case a number of years ago. But in recent years, we went back to the standard configuration. The reasoning why we went that way was our testing showed no difference in torch temps and...

Again, that is major site building problems. We have talked about it enough on our forums and facebook pages that it is mostly known. Also if it is something large that comes through, most of the...

Yes, because it requires a major site design change. On a site largely hand built, it is hard wired into it so to speak. We've got a new site coming on board at some point, but at this point it's...