Search:

Type: Posts; User: racinjason44

Search: Search took 0.01 seconds.

  1. Replies
    11
    Views
    6,576

    I talked to Mike for quite a bit Friday, very...

    I talked to Mike for quite a bit Friday, very helpful guy. Anyways, I am still having issues with my welder, I know my foot pedal is not working as it should be, it reads extremely erratic on the...
  2. Replies
    11
    Views
    6,576

    Thanks Mike, for the help. I took the case off...

    Thanks Mike, for the help. I took the case off and discovered I had a plug behind the panel disconnected, the machine is working as it should. :D

    I tested the regulator with soapy water, it is...
  3. Replies
    11
    Views
    6,576

    I have been trying to reach you guys all morning...

    I have been trying to reach you guys all morning but have not got through. :confused:
  4. Replies
    11
    Views
    6,576

    Thanks, email sent!

    Thanks, email sent!
  5. Replies
    11
    Views
    6,576

    having some problems with my PM205

    For the most part I am happy with my machine, but I am having a couple of issues. For one, the foot pedal control does not work as it is supposed to. The only way to get any kind of control is to use...
  6. Thanks, I think I have it figured out now. I even...

    Thanks, I think I have it figured out now. I even ran it in 4 step mode using only panel settings. I like being able to start and stop with just the torch, that's going to work out nice on awkwardly...
  7. Replies
    8
    Views
    6,792

    I am getting different readings, I will send you...

    I am getting different readings, I will send you a PM.
  8. Replies
    8
    Views
    6,792

    How late will you be available? I need to run out...

    How late will you be available? I need to run out an get a new battery for my multimeter.
  9. I recently purchased a PM205 from you as well,...

    I recently purchased a PM205 from you as well, and I have questions of a similar nature. Is the knob on the foot pedal tied to the red main amperage knob on the machine? For example, if I were to set...
  10. Replies
    8
    Views
    6,792

    I seem to be having a similair issue with my...

    I seem to be having a similair issue with my PowerMaster 205. I took my foot control box apart, and the rack gear was sliding off the gear on the rheostat, but I still have this problem after fixing...
Results 1 to 10 of 11