Search:

Type: Posts; User: dsthompson

Search: Search took 0.01 seconds.

  1. Replies
    1
    Views
    2,279

    Weld 1/8" thick square tube to 1/2" base

    Hello all,

    I need advice. I am going to build a gazebo of sorts. It will consist of 3x3, 1/8" thick square tube sticks.

    I will have shades and the like on it and it could behave like a sail so...
  2. Replies
    1
    Views
    4,859

    10lb spool in 200e

    So in my 200e I have a 10lb spool of .035.

    I was welding away today and experienced a case of the wire not maintaining the set speed. It got slower and slower. It continued this even after I...
  3. Replies
    1
    Views
    7,214

    Build Square Tube from Flat Stock

    So I need a tube, 1.25" to use as a ball mount to pull a small utility trailer.

    The local metal supplier doesn't have square tube with the same wall thickness as the store bought tube (3/8" I...
  4. Replies
    1
    Views
    6,060

    Preheating in an oven

    So here is the next in my long list of stupid welding questions.

    200e running on a 30 amp 110 volt circuit.

    I am going to weld up a trailer hitch insert...so the part the ball sits on. I have...
  5. Thread: Texas.

    by dsthompson
    Replies
    2
    Views
    2,156

    BTW, I posted my two questions in the general...

    BTW, I posted my two questions in the general welding forum. Probably best to answer then there if you were of a mind to.

    Thanks
  6. Replies
    1
    Views
    6,172

    Generic Voltage and Wire Speed Settings

    So I have a new 200E.

    I am in the process of mapping the dashes on the dials to real world measurements (FPM and voltage) and for that I have a question. I am currently using a 110 circuit but...
  7. Thread: Texas.

    by dsthompson
    Replies
    2
    Views
    2,156

    Texas.

    Apparently we are supposed to show where we are.

    So I have been welding for a few years off and on. I burned up a Crutchfield Hauser or some such cheap welder bought off of Craigslist. I'm not...
Results 1 to 7 of 7