Search:

Type: Posts; User: Rodzilla

Search: Search took 0.05 seconds.

  1. Replies
    11
    Views
    322

    Thanks for the input, much appreciated.

    Thanks for the input, much appreciated.
  2. Replies
    11
    Views
    322

    I'd say your likely right. But the other 2...

    I'd say your likely right. But the other 2 machines have 100% at 200 amps. For 95% of the time the 210 would be more then I needed. But on days where your running constant welds on large aluminum...
  3. Replies
    11
    Views
    322

    I already know the 210 is out, duty cycle not...

    I already know the 210 is out, duty cycle not there for what I may need from time to time.
  4. Replies
    11
    Views
    322

    Which Tig Machine?

    Hey folks, looking to get a new Tig machine. A few years ago I had a 250EX, but then moved and had to sell it. I'm looking to replace it and need a unit that is reliable enough to do project work...
  5. Replies
    7
    Views
    836

    I'd have it set at 80, so once it was running it...

    I'd have it set at 80, so once it was running it would drop to 72-74.
  6. Replies
    7
    Views
    836

    Not on during these pics. But it was.

    Not on during these pics. But it was.
  7. Replies
    7
    Views
    836

    Thanks for replying. Air is ok. I have a gauge at...

    Thanks for replying. Air is ok. I have a gauge at the machine regulator. As well as the machine shows good itself. Cutting height is .0600" and I run THC. I have a dryer between the compressor and...
  8. Replies
    7
    Views
    836

    Well talking to others I did find that the...

    Well talking to others I did find that the plunger in the torch head is sticking. Would that cause tips to burn up at a quicker pace?
  9. Replies
    7
    Views
    836

    Problems with my PTM80 Machine Torch

    I purchased an 82i machine early this year to go with my DIY plasma table. I've had everything up and running for a couple weeks now. And have mostly been working on dialing the table in. Its a 5x5,...
  10. Replies
    8
    Views
    2,615

    Thanks guys,,,I will give these ideas a try.

    Thanks guys,,,I will give these ideas a try.
  11. Replies
    8
    Views
    2,615

    This was same advice I received on another forum....

    This was same advice I received on another forum. I'm going to give that a try, thanks. Like I mentioned over there, I'm going to need new eyes to keep an arc that short and move fast enough not to...
  12. Replies
    8
    Views
    2,615

    Am I having gas issues?

    Bad gas? Or leak I can't find? Not to sure, anytime I try to run a bead I start with a clean electrode, sharped parallel to the tungsten rod. I was going to buy 2% lanthanated but they didn't have it...
  13. Replies
    3
    Views
    1,453

    Anything else I should know about that might be...

    Anything else I should know about that might be different with the digital unit?
  14. Replies
    3
    Views
    1,453

    Ok. Thanks, just making sure someone at the...

    Ok. Thanks, just making sure someone at the factory wasn't sleeping when applying the labelling. :)
  15. Replies
    3
    Views
    1,453

    New 250EX question

    Just setting up the machine and cooler. All of my literature has the positive on the left and negative on the right for the ground and torch inputs. My machines actual labels are opposite, did they...
Results 1 to 15 of 15