Search:

Is there a hand held plasma torch that would work with the older power plasma 60c?

I'm no electronic guru but, I do know the amp of the breaker has something to do with the duty cycle of the Imig 200. When I used mine on a 30 amp breaker I could bump the duty cycle. I carried it...

13403
I'm guessing these are the points, I took some fine grit sand paper and cleaned them up. I have not had a chance to use the welder.

Yes it does have a buzzing sound. How do I check the points?

I've been trying to use my 225lx with the 2t & 4t switch. I am having trouble getting the welder to fire off. It seems that I have to touch the metal before it will start welding. It is acting...

Thanks! I've been busy, I need to order me a pedal and make a cooler or sell the welder!

.

I will look at it, but I'm thinking about getting a smaller pedal.

I ran a power arc 200 on a power horse 7000 from Northern Tool for a solid two years without any issues. I ran it till I could afford an engine drive. When people ask me what I started with I tell...

I've been pretty busy at work and side jobs; so I finally dug out my 225lx last week. The welder fires up just fine when I use the 2t and 4t switch. I'm guessing it's something to do with the foot...

I will check it when I get off work, thanks.

Thanks, where are the points located?

I am having some issues with my 225lx and want to make sure I am not doing something wrong. I have used the welder just a few times in the 3 years I have owned it. I am having trouble getting it to ...

For that THC you will need to wire on the inside of the machine. This is so it can read full voltage. I had the same issue, but I moved and never fixed it. You would do that if you had a...

It was shipping damage. It sat in the box for a couple of weeks

I need need to sell this machine, it's an excellent welder I'll take $800.00.

Lots if times you can get the best deal off the truck. I gave back two airgas lease bottles

Ok, I just assumed it would weigh less. I want something that is easier to carry.

I've owned this welder for over a year and have welded with it 2-3 times. What little I have used it mig welding I do like it very much. I ordered a 200MTS from Amazon and was sent a 250MTS. I...

I believe this discussion has been tossed around a few times on the board. I agree with geezer; I used a NT Powerhorse 7000 for a good 2 plus years. I believe most new generators are going to be...

7018AC is a great option for inverter style welders in my opinion. 7014 is known as the sheet metal rod, and I personally find it to work very well on thin metals. I use 7018 (H4R) 1/8 Lincoln...

I have the harbor freight notcher and I have been happy with it. I do use good hole saws which I'm sure helps. I do plan to add some shims to mine.

Optimum conditions are the key! I will say that dry air makes a dramatic difference. I've owned a high frequency cutter with touch start that I felt had a good consumable life. A high frequency...

I already thought it was a very reliable welder! I'm not sure that I've even read any issues on the forums.:D

10476
Power Arc 140

One of the best investments I have made is a 100ft 10 gauge heavy duty extension cord. I have an air compressor that will trip its breaker with any cord thinner than 12 gauge. You would probably be...