Printable View
The new forum uses different views and foreign key's so the data doesn't come straight over, you have to run the conversion against the database to update the schema. Sounds like that's the part that was missed. Oh well, too late to run it now. LOL.. Been there done that....Quote:
Originally Posted by angular
Pretty close Sschefer,
The schema was updated ok , but the indexing was fubar, Mike did the work , but we don’t have direct access to the Db server so had to work through a supplied UI, turns out Mike ended up deleting all the indexes then rebuilding them all. I didn’t get a chance to poke at it (I hate DBA stuff anyway) but Mike worked his A$$ off on it. ,
If you get a chance... next time you have the cover off shoot me an e-mail (btp -> s16v.com) or call me (two five three 951-4712). There are three places inside my unit where components have been cut or are missing, so I'd like to compare.Quote:
Originally Posted by Adambomb
Diode V55 here on the main board up top:
http://s16v.com/photos/2011/01-29/P1...oken-diode.JPG
1K resistor (next to diode V79) on the main board up top, near the front:
http://s16v.com/photos/2011/01-29/P1...n-resistor.JPG
Capacitor C9 on vertical board mounted near front on left side (when looking at front panel):
http://s16v.com/photos/2011/01-29/P1...-capacitor.JPG
Thanks.
Bradley
Sorry for the delay Bradley, but I replaced my rear cover today and checked my unit against the pics you provided. In each of the three locations, I had the same modifications. My unit functions perfectly now, so if you still have any issues it is not because of these particular mods. ;)Attachment 1206Attachment 1207Attachment 1208
To illistrate how well the welder is working, here is 2 titanium coupons, .015" thick autogenously lap welded together. I'm looking forward to getting a back purge set up to do the welds properly.Attachment 1209 I'm also looking forward to getting some titanium tig rod and making a custom Ti battery box for my old Kaw :cool:
Adam... thank you very much! I got your voice message and really appreciate you taking the time to post the pictures. I definitely feel better knowing your 250EX is the same as mine.
You're welcome Bradley :cool: I hope you got your machine squared away and running right. I just refilled my argon tank for the first time. Considering the amount of actual welding time I have put in, the 248 cuft cylinder should have lasted quite a bit longer. It would seem that I had a small leak at the tank fitting, since anytime I turned the valve off the residual pressure would bleed off in 15 minutes. :confused: At first I thought I might have gotten one of the cracked regulators, but I could not find any evidence that there was anything wrong with it. Now that I have a new bottle, it holds pressure just fine. I think it was the bottle I had :cool:
YAY! My WP20 torch arrived today. I ripped it out of the package, and.....it's soooooo tiny! Here is the stocker next to the 20 torchAttachment 1223
OK guys, I ran into a small snag. When I went to assemble my new torch, I couldn't get the cup to thread onto the collet body. It seems there were not enough threads exposed past the insulator to even get the cup started on the collet body. This was with the collet body threaded on fully and seated in the torch head. Has anyone else had a similar circumstance with their everlast WP20 torch?
On top is the collet, gas lense and cup I just bought. On the bottom is the stock supplied parts. The gas lense and associated cup fits just fine, But the stock parts are a little iffy. I'm sure I must be doing something wrong, since I checked the stock collet body against one at the LWS, and they looked identical.Attachment 1224