PowerArc 200 with no 6010 port

Thanks for the report...:)

Quote:

---

Originally Posted by performance

I did just get a reply from the factory that it was revamped, to work for BOTH 6010 and 7018 in the same port. I am little miffed on being left out of "their" decision to change, since we haven't asked for any change. Scooter, when you get it try it. If it doesn't work on 6010 well, then we will make it right.

---

So If I order a PowerARC 200, which one will I get? The two port, or the three port model?

Don <><

In regards to different arc voltages, I hooked my volt meter up to my stick welder and filmed the screen while i welded. I tried an 1/8 6011 and an 3/32 7018. the 6011 ran between 26 and 30 volts while the 7018 ran between 20 and 22 volts. Both were ran at the same setting of 90 amps dcep. I will try to put the video up on YouTube.