Itig 200 arch issues?

Hey guys! New to the forum and wanted to pick your brain about some possible troubleshooting. I bought the Itig 200 digital welder last year and its been welding great for the the last 9 months. Recently it started acting up and not wanting to start the HF arch and now it doesn't want to scratch or HF arch. Still works great in stick mode so I know the power supply is good. If you press the foot pedal it doesn't immediately open the gas solenoid, but if you press it a few times in a row it might open it for a second, but still no power to the torch. No warning lights or codes pop up either. Everlast thought it could be the foot pedal. I replaced it and it still doesn't show any signs of life. Any suggestions?

I appreciate the help my welding brothers!

Call tech support. I think it still could be a switch in the pedal or it could be a relay sticking inside.