200 DX Basic Settings

Hi, Can some one tell how to do a basic set up on my DX200.
I want to start out doing some .20 gauge sheet metal.
Need to know about where to dial things in to get started..

Thanks, Rob..

Hey, Rob-
You can find a TIG calculator here:
http://www.everlastgenerators.com/ti...calculator.php

It will give you basic settings to get started. The dropdown for stainless steel also applies to steel.

A couple things: 20 gauge sheet is about 0.04", which is pretty thin... my apologies in advance because I don't know how experienced you are, but if you're just starting out you may find thicker practice material more forgiving until you get into the groove.

Also, some sheet metal is galvanized, and you should remove the galvanizing prior to welding. Burning through it creates toxic fumes. TIG is a very clean process (typically no sparks or smoke) but requires a lot of surface prep prior to welding.

Again, I don't mean to preach, just not sure how experienced you are- apologies for the lecture!

Dave O

I don't remember the exact patch panel material I welded into my project car last month (20 or 22ga, whatever scrap I had lying around), but I used the torch switch with amps set at 17-20. I started at 17 and it was slightly too cold, so I bumped it up a few amps and hit the sweet spot.

This was with a 3/32" tapered needle point on the tungsten, .035" mig wire, and no gap between the work pieces (this particular weld was a butt joint). My little PA 160STH has no pulse features either (for the record).

Judge your amps by how easy things tack up. You may have to go as high as mid 20's (or so) on amps since my numbers above might have been for 22ga, not 20. If you can, use copper backing to help keep the panel from warping.

Andy