Printable View
Machine: PowerTig 250ex
Cooler: Power Cool W300
I'm looking for extra male fittings for the water cooler-to-torch hose connection and the torch gas outlet on the front of the machine. Are these standard fittings that I should be able to purchase from my LWS store?
I purchased a wp20 torch and didn't even thing about fittings.
They are 9mm quick connects. You can check this thread for some part numbers and places to get. You might even be able to buy from them as they had to order extras to meet a minimum.Quote:
Originally Posted by AWDnot2
http://www.everlastgenerators.com/fo...hread.php/3262
I ordered my three directly from Everlast when I placed an order for A81 consumables. I did have to purchase spring hose clamps at the local hardware store. I think the Male Quick Disconnects were less than $5.00 ea.
So the argon and water use the same QC?
I use two of the three Quick disconnects the water return quick disconnect was included when I purchased the CKSLWHAT-35-QD power/water return connector. One was used on the PP256’s Argon/air connector and the other QD was used with the W300’s Water supply, Blue QD female connector. As in another topic the Everlast Male Quick Disconnects did NOT come with a clamp.
Hi -
You can buy female threaded connections with the appropriate male QD for the water lines from ArcZone. This will allow you to just thread the adaptor directly onto your new torches water lines and then plug directly into the water cooler. The part number is ZHCK-W. Bought 2 back in Feb 2012 for $10 + shipping. These adaptors have left handed threads.
For the gas connection you'll have to cut the threaded end off your new torch gas line and install a barbed QD. You can get these barbed QD's from weldingdirect.com, Part number 501N0114. I couldn't find a right hand female threaded connector with the correct QD on the other end. Arczone has one that looks right for the gas line but it IS NOT. QD is too small (P/N ZHCK-G won't work).
If you need the water thru dinse for the power connection CK-SLWHAT-35 will work. Got mine from arczone.
Hope this helps
Thank you, guys. Sorry I didn't reply back sooner. It's been a busy week. By the time I have time to sit down, it's already bed time.
Yea, ZHCK-G is a 5mm connection. Does anybody know where we can get the RH threaded quick connect for gas line? I don't want to cut my wp20 with "standard" RH B size fitting to make it fit my Everlast welder.Quote:
Arczone has one that looks right for the gas line but it IS NOT. QD is too small (P/N ZHCK-G won't work).