Plasma cutter adjustment torch

Hi Mark
I was doing a last minute Christmas wish list!
What does this adjustment do?

"Plasma cutter adjustment torch in EVERLAST is used for the purpose of 40/50 AMP Tig Torch with Adjust Knob. This acts as an accessory for welding"

305 Model: Plasma Cutter Adjustment Torch
Category: Accessories
Purpose: EVERLAST 40/50 AMP Tig Torch with Adjust Knob
Price: $ 119.99

This is very confusing does it allow you to use the plasma cutter as a tig welder or is it miss labeled and is a plasma torch cutting power remote? looking as close as I can in the picture it doesn't look like a tig handle.
Thank You
dwdw

Where is the link?

I have an idea it is goof up of the web guy.

Here is the link to the item: model 305

http://www.everlastgenerators.com/pr...tegory-60.html

http://www.everlastgenerators.com/Pl...ch-305-pd.html

Sorry I didn't give the link to the web page.
dwdw

LOL...
Sometimes you just have to laugh at yourself or your company. I believe after working with our web guy for the past month or two, I understand why that happened. I believe the delays in the site speak volumes. We are too far in it now to back out. It is nice. I'd like to give a sneek peak (its there but you got to have the magic wand to make it appear), but I am afraid of the flood of questions when everything hasn't been tidied up yet. IF we were to compare building a website to building a house, we are past the dried in stage, and the trim has been done, but the paint is still wet on the walls, the cleanup guy is sweeping up the drywall dust off the fresh laid tiles and the landscape crew is rolling out the sod. A few light covers still need to be screwed in place and the inspector is on his way....

That is a gas valve tig torch, used for TIG welding from non valve DC power sources.

Mark its all clear now! Don't you think that would have been great to be able to adjust the plasma cutter when your 20 ft in a the air cutting an outlet in a duct!

Now were in the snow removal mode, wet snow and a lot of it.
Playing will have to wait.
Thanks
dwdw