Using a 40 amp plasma torch on the PM-256
Since the PM-256 is about 20-60 amp on the plasma cutting
Would it be better for a long run of the thinner 24 to 8 gauge,to buy a 40 amp plasma torch than use the higher 80~amp torch which I remember is being shipped with the new PM-256?
Just a thought doesn't running a plasma torch at the low end waste the consumable or does it matter?
Would a smaller plasma torch like a 40 amp fit? The fitting in the picture looks the same.
Sorry for all the questions
I just want to order what I need at one time.
Thank You
dwdw