Mean Green Contest - Project 1 - Jeep Bumper Support

This Jeep belongs to a lady, her husband bought it for her as an anniversary gift. She has completely disassembled the Jeep, and doing a complete restoration.
Everlast Products used: Imig 200 & Everlast SuperCut50P
I normally charge a $75.00 minimum if I come to someone's place and weld. In Memphis I charged $85.00 minimum (1 hour). I charged $50.00 for this little job. It's a pain getting loaded up to go weld, but it's hard to charge more for a small job, and at the same time hard to charge any less.
http://i32.photobucket.com/albums/d2...3-19115522.jpg

The original bolt had been worked on pretty good. I used my SuperCut50P this was my first time ever using my new plasma cutter.
http://i32.photobucket.com/albums/d2...3-19124603.jpg

http://i32.photobucket.com/albums/d2...3-19124608.jpg

There were nuts tacked to the frame from the factory.
http://i32.photobucket.com/albums/d2...3-19115527.jpg

Left side
http://i32.photobucket.com/albums/d2...3-19124918.jpg

Right Side
http://i32.photobucket.com/albums/d2...3-19125233.jpg

Here is the bumper support ready to go.
http://i32.photobucket.com/albums/d2...3-19125233.jpg