Project #5 Home Made Scrolling Wrench
I had some scrap left over after making my Broadfork. The 1/2 by 14" Cold rolled piece was from the scrap yard and one end already had two flat surfaces machined into it. this made it easier to weld a couple of 1.25" inch pieces of scrap to. After boogering up the weld, I clamped it in a vice and tried to eyeball a simple scroll.
http://i1261.photobucket.com/albums/...h/CIMG2944.jpg
http://i1261.photobucket.com/albums/...h/CIMG2946.jpg
http://i1261.photobucket.com/albums/...h/CIMG2945.jpg
http://i1261.photobucket.com/albums/...h/CIMG2952.jpg
http://i1261.photobucket.com/albums/...h/CIMG2953.jpg
I am sure I would get better if I had a bigger project, well actually I would make a jig for a bigger project but it's a handy tool to adjust a scroll to fit a space in a gate or fence.