Smaller tips for A81 torch?

Are there smaller tips than 1.0 for the A81 torch? We have been using an old Matco plasma with I think 12.5 to 20 amps and .6 to .8 tips to cut off quarter-panels and such.

The 70 amp plasma cutter with a 1.0 tip is overwhelming for cutting off quarter panels. Would a smaller torch that is designed for a 20 amp plasma with smaller tips make this big plasma cut more like the smaller machines do on thin sheet-metal?

if you go to fitamet site ,they only list 1.2 and 1.0`s tips, i`ve cut sheetmetal with both 1.2 and 1.0 tips, the 1.0 does a clean knife cut when set corectly

I'd suggest looking at the PP50, instead. It'll handle a lot of different ranges as well. The s-45 is pretty good on thinner stuff.