Can I add a 20' mig torch to my Imig 200?
Printable View
Can I add a 20' mig torch to my Imig 200?
What about the ability of the wirefeed to push wire that far, around potential bends / curves etc? Is that a question mark?
If it has a euro connector this one will work... http://www.everlastgenerators.com/fo...-my-I-MIG-250p I like it much much better than the OEM. It's a little pricey but worth it.Quote:
Originally Posted by SeanMurphy265
Sean,
It shouldn't be an issue, but keep in mind, bends will foul up even a short one on feeding at times. The longer it is, the straighter you will want it to run.
I find it easier to work with a longer cable. There's always plenty of slack so the cable doesn't get pulled into tight bends.