Printable View
Here are some pictures of the press. The middle bottom and frame. Not sure what order they are in cause I can not figure out upload.
Top of frame
Attachment 2690
base shelf
Attachment 2689
Spring locations
Attachment 2688
Complete no sanding no paint but can use it
Attachment 2687
Brake added
Attachment 2686
1/4" piece bent, did 1/2 to and it cracked
Attachment 2685
Attachment 2691
Middle for jack before welding. They are no in order sorry
Attachment 2692
Well it got paint yesterday. Could not pick a color. Took hunter green and sunny yellow. A lot of yellow. Match the welders now. lol
Added a place for jack handle
Attachment 2778
Used rustoleum
Attachment 2779
All done.
Attachment 2780
The handles on the sides were bent on the press with the brake I made too
Nice! What is the largest width you can bend? I would love to build one that could bend 3'-4' pieces of 12 gauge.
So far 1/2" by 2 I have done with no problem. Last post I did in the brake thread was 6"x1/4" with no problem either. It is pretty strong.
Your projects look good, whats next on your build list?
Scooter,
I fixed a clamp for my Dad last night. A cheap plastic Harbor Freight one now steel on one end. Will post picture in a second.
Oh yea I will be fixing a poolman's trailer tonight will try to get picture.
Where did you get the jack at Harbor Freight? I can deffinately see this on my build list very soon
The jack is from Harbor Freight. Itwas $34.95 on sale.
Poolman backed out but welded a 22' trailer tounge last night. Will try and to get pictures today. Not much work just to stop it from rattling.