All Blog Entries

  1. powertig 250 ex foot pedal problems

    i have owned a 250ex now for 3 weeks and going on my 3rd foot pedal all the pot switchs go bad, im getting a new pedal again today i will try another. any suggestion as to what is going on, can i get a better pot switch for these pedals??

    Denis
    Categories
    Uncategorized
  2. Starting at the ground floor

    Quote Originally Posted by everlastsupport View Post
    If you are talking to me. I think you're missing my point. And I have a BSEE, so the higher learning commit, well.

    I have met many people that have never had a welding class, building 75K-500K+ cars and much more. It's not a requirement. Certs are not either. I would look more at a cert than a class. And CGCINC expressed his TIG class, so no too are the same.

    I am glad you liked your class, you voiced that, but it is not for everyone, as I voiced that.
    ...
    Categories
    Uncategorized
  3. New PowerPeo 205S has arrived

    Quote Originally Posted by jbirdlebough View Post
    Took some time to get here. Did through inspection internally always a good idea on any new system to insure little things like solder joints and wires are still attached and not run over places where they can cause trouble.

    Added dual GAS manifold, with common water filter, two isolation valves and the GAS 1 compressed air for plasma custter regulator and GAS 2 for Argon regulator output.

    Spent last night re-reading the manual. Tomorrow we drag it to the barn,
    ...
    Categories
    Uncategorized
  4. Which power connections should I use for the plasma 50P?

    Quote Originally Posted by Justinta View Post
    Model SuperCut50P No255703962

    I just would like to know if its a 220v 50amp plug or 110v 15 amp plug. At what amperage should I protect the unit ,is it 40 because its name plate says IMAX = 39 amps, but the power cord supplied and connected to the back of the unit is only 14 gauge which is rated for 15 amps.

    Is there any internal protection built in to protect the unit at 40amps? Could I put a 50 amp plug on the cord connected to the plasma cutter, my only welder
    ...
    Categories
    Uncategorized
  5. Shopping For Boom Lorries For Sale

    Match parts boom trailers and a cargo or dump truck, forestrybucket truckss are extremely specialized equipment. Used to care for, or that can prune tall trees, these trucks assist with very specific should have. Forestry trucks tend to be created to reach good branches, and are really usually mounted as well as articulated telescoping booms. The at the same time have provisions when considering storing lumber or debris that has to be hauled off.

    Original trucks lose regarding green ...
Page 3 of 7 FirstFirst 12345 ... LastLast