Activity Stream

Yeah, Nice call on checking them anyway. You solved the mystery!

After pulling machine out of cart and pulling cover, I lightly blew out any dust. Not much if any in there. Tried a .035 feeler gauge and could not...

I have LPM gas flow gauge. Set at about 8 LPM,#8 cup. 2T pedal. I have a aftermarket pedal,Ss or something or another. I can put switch on but pedal...

Gee, Maybe you have the gas set with too much velocity. What's your CFH and cup size? Maybe you have pre-flow set too long. Try none, or .5...

The 200 is the better of the two.

It sounds as if it is in 4T. Move to 2T or pedal mode. Unfortunately that factory folded up as far as I know. We moved production to our other...

They will until they go out of business doing it. If the unit failed after shipping it back to you, then you need to contact the company direct....

I previously had the big water-cooled torch. Yes, machine has direct plug for water cooler. I think you?re right. At some point I smoked the original...

Nice, So, you probably just smoked the previous torch/cable/hose then? Was it gas-cooled, and now you're going to water-cooled? I'd check...

Sometimes we just get lucky... just before my 250EX quit working, I ordered a 20 series 25? torch. It arrived and when I hooked it up, machine worked.

Well, I took the bench made with some free wood and rebar concept a little further down the proverbial rabbit hole, by actually purchasing some...

Call, Everlast, Their phone tech service may not be contingent on the warrantee length. I mean, Mark, from Everlast, monitors this forum and...

Yeah, I wouldn't recommend any 115V MIG unit, especially a heavy transformer one, as it may not give you it's full rated output without a 30 amp...

IF a customer wants to keep their warranty in effect, then they should follow our advice. You can bet and suppose a lot here. Fine, but when it...

I'm sorry MC5W. But lets not revive 5 year old threads. Inverter welders can use lower amperages because of Arc force, but that will depend upon...

No. The torch stays in the negative for all TIG operation. Download your manual from the website. It is up on it. It covers pretty much everything...

Spot settings will get you everytime.

Inductance 75%. Start there. The results will vary based off the user's experience in setting a manual pulse. The 350P is a type of synergic pulse....

CallMeBurton, The Method To The Madness is that with some brands of water cooled TIG torches and water coolers the water fittings have left handed...

Hi Barry, I am glad that the ampere reduction when going from straight argon to a helium + argon mix is 1.5:1 . I also read somewhere or saw on...

Yeah, If you booger the tungsten up too bad, a flap-disc on an angle-grinder will do very well, in a pinch.