Activity Stream

Hi, This is my first post. My name is Mike Cole. I have done some research on propylene glycol antifreeze for water cooled TIG torches and...

Finally ready to pull the trigger on a 200DV. Is there any reason to order directly from everlast? Any pros or cons? I would assume the warranty is...

Looking at the 250EX specifically for the spot timer function. Wondering if i can get away with a lower model and get the same or similar results...

Hey everyone, noob here. I'm attempting to feed some 0.035 ER 70S-6 wire through my new Lightning MTS 275. This is its maiden voyage, never used it...

Hello everyone. I am pretty new to welding except for the HH140 we have at work that tac with every once in a while. I am looking for a welder for my...

I looked up DINSE SKS 120 plug and found on the American website 2 different versions of the same PDF document and on their European website 2...

I've looked on the consumables page and noticed there's a gap regard amperage range. They start 40 amp and go up to 60 amp but skip up 90-100. Any...

Hi Need some wisdom from the board. My son and I picked up a 52i plasma cutter for some project around the house. The typical work would be...

my power pro 256 has stopped working . I get an arc across the points but nothing beyond that , no plasme, no tig and no stick. the overheat light...

I cannot refind the thread but somebody asked a product question to effect, "Can any of the large machines be built to accept 380 volts 3-phase 50...

Hello. I am new to welding and looking at getting my first welder. I was looking at purchasing a Hobart HH140, then I saw videos on the Everlast...

Anyone have a chart with some basic settings for Pulse mode on the 275P? I have welded at work with a Miller 350p pluse welder for 10 years and it is...

I have just received my 200DX. Never welded with AC before, only DC steel. Do I need to switch cables around or does the machine take care of...

Hi, I haven't used my tig machine 210EXT in a couple of years. When I attempted to, I could not strike an arc. The high frequency works well, but...

I have a TIG 250 EX welder. I would like to replace the water cooled hose and torch for an air cooled 17 hose and handle. Does the one offered on...

After some soul searching and being informed repairs will take 30 to 40 days I have decided to sell my welder in its current condition (broken) I...

How durable are the newer orange torch lines? Do they still need to be wrapped?

I was welding with my 250EX an lost high freq. so I uncovered it, adjusted points. Great! Back to welding beautifully! After about an hour, it...

After working with tech support since March finally got somebody to listen, pull trigger air flows but no plasma. as I said got RMA and since it's...