Loose amperage knob?
The amperage knob on my new 200DX seems excessively loose...far more so than any of the other smaller knobs...to the point even that I cant envision it engaging the pot, as it seems there should be at least SOME drag. Is this typical and does it warrant getting into the unit? Just pulled it out of the box and havent wired up the plug or anything, but before I did, figured Id see if anyone had this issue or if it is normal. Ran home from work over lunch to open it lol...now back at work and it will have to wait till later.
Everlast PowerTig 200DX
Everlast PowerPlasma 50
Old 90 amp flux core wire feed
HF 90/160 Amp TIG/Stick
Mini Lathe, Mini Mill, Manual Bender, Ring Roller
HF 2HP 29 Gallon Belt Drive Compressor
8" plate shear, homemade 3-4 ton bench punch
Homemade H-frame press, aluminum casting furnace
HF 12 speed 3/4hp Drill Press, Clarke 4x6 bandsaw
Chop saw, 10" disc sander, 10" Mitre saw modified for aluminum
Makita for the power tools that matter, HF for the ones that dont (or are too expensive)