Originally Posted by jbirdlebough Took some time to get here. Did through inspection internally always a good idea on any new system to insure little things like solder joints and wires are still attached and not run over places where they can cause trouble. Added dual GAS manifold, with common water filter, two isolation valves and the GAS 1 compressed air for plasma custter regulator and GAS 2 for Argon regulator output. Spent last night re-reading the manual. Tomorrow we drag it to the barn, ...
Originally Posted by Justinta Model SuperCut50P No255703962 I just would like to know if its a 220v 50amp plug or 110v 15 amp plug. At what amperage should I protect the unit ,is it 40 because its name plate says IMAX = 39 amps, but the power cord supplied and connected to the back of the unit is only 14 gauge which is rated for 15 amps. Is there any internal protection built in to protect the unit at 40amps? Could I put a 50 amp plug on the cord connected to the plasma cutter, my only welder ...
Archive
Recent Comments