Trailer Gate project for 16' trailer

[chadford]

My Dad picked up this 16' dual axle trailer for $200. This is after a lot of cleanup. It had no gate and he wanted a matching gate to match his 10' trailer. Again not a lot of pictures. Used square tube frame and expanded mesh. Bolted on aluminum fenders to. IMIG-250P used this time. Dad took pictures of me welding henge on. Not bad for $200. Fenders are now black. Will take another picture of it done later if I get time

2826

2827

[Scooter]

Great deal on the trailer, the ramp looks good. You are sure keeping busy and helping your dad out. Your dad should be very proud of you.
Scooter

[chadford]

Thanks Scooter he does tend to work my but off but I like to weld. Here is a picture of the gate it was backed in the woods and my brothers plants so best I could get. Will upload picture of the one I copied like your brake :O. but the press was all mine minus jack.

2934

[chadford]

here is our 5x10 I copied just wider.

2935

[scootarida1]

That looks really good, now u don't have to put boards up to get whatever you need on the trailer

[chadford]

That looks really good, now u don't have to put boards up to get whatever you need on the trailer

Nope and it is removable to. Heavy but two people can take it right off